gprichar
asked on
DOS Boot DIsk Client to NT via TCP/IP
I am trying to set up a DOS boot disk which will allow us to log on to an NT domain via TCP/IP over a router.
- Has anyone done this?
- What client should I use - Lanman 2.2c or MS Network Client for DOS 3.0?
LM2.2c seems smaller but MS Knowledge base articlw Q142367 suggests there's a problem getting over a router.
Also, can NIC drivers be loaded AFTER boot-up (i.e not from config.sys)? If so, how? We need to develop a NIC autodetect process for the cards we support.
Any pointers will be greatly appreciated.
---- Gary ----
- Has anyone done this?
- What client should I use - Lanman 2.2c or MS Network Client for DOS 3.0?
LM2.2c seems smaller but MS Knowledge base articlw Q142367 suggests there's a problem getting over a router.
Also, can NIC drivers be loaded AFTER boot-up (i.e not from config.sys)? If so, how? We need to develop a NIC autodetect process for the cards we support.
Any pointers will be greatly appreciated.
---- Gary ----
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.