malakhov
asked on
Same hardware found on every reboot
Hi
I have S3 Virge vid.adapter from Leadtek. It was properly(?) installed and
works fine. The problem is that on every reboot NT sees it as "new hardware
found" and tries to install it anew, saying that all the necessary files
are already on HD and I can skip copying them from installation CD. I tried
both ways and still, next time I start, NT writes: "New hardware (WinFast
3D S600) found. NT is installing the software for it". I did try to point to the drivers directly through Display Properties, Change driver or display type or smth, to no avail. How do fix that?
Any help would be appreciated.
Dima Malakhov
I have S3 Virge vid.adapter from Leadtek. It was properly(?) installed and
works fine. The problem is that on every reboot NT sees it as "new hardware
found" and tries to install it anew, saying that all the necessary files
are already on HD and I can skip copying them from installation CD. I tried
both ways and still, next time I start, NT writes: "New hardware (WinFast
3D S600) found. NT is installing the software for it". I did try to point to the drivers directly through Display Properties, Change driver or display type or smth, to no avail. How do fix that?
Any help would be appreciated.
Dima Malakhov
ASKER
I am running NT4.0 sp2 installes
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I am a novice, could you tell more about what files exactly should I look for?
Thanx in advance
Dima
Thanx in advance
Dima
--->John
email: john.matasovsky@bigfoot.co