file cdrom.sys corrupted during install

I'm trying to install a NT 4.0 Server from a CD-ROM. During the file copy operation it goes so well, but after it does the first boot, I get the message "The file cdrom.sys is corrupted. Setup failed."
The file cdrom.sys is OK on the CD - I just copied it to my hard disk, with no problems.
PS.: I have tried to install from the same hard disk, too!
Any help? Please!
moro@mmq-net.com.br
moroAsked:
Who is Participating?
 
sergio010697Commented:
You could try to interrupt the 1st boot inserting a DOS boot diskette with all drivers to enable the CD-ROM, copy the corrupted file from the CD to the install directory and then, remove the diskete reboot allow the NT to complete the install procedure.
Good luck

0
 
moroAuthor Commented:
I have tried that already! Think I'm going to change the CD on Microsoft. Thank You!
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.