mariop051997
asked on
SYS1200 code 002 error during bootup
I've been getting this error message: "SYS1200, code 002."
How can I restore the OS/2 DOS capabilities I seem to have lost?
How can I restore the OS/2 DOS capabilities I seem to have lost?
ASKER
Adjusted points to 100
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
I seem to remember obtaining a similar error after a failed attempt to install a video driver. The install had placed a few lines in my config.sys but did not finish to the point that these lines could be used.