ironclaw
asked on
APC Pin out for NT Ups software
Using an apc 400 ups with the ability to run power chute, what are the pin setting on the female end ( ups) and the male end ( com port), to let you use the ups software with windows Nt 4.0, i am considering wireing the cable myself to save some $$$$$.
Thanx
Ps. Will this work?( mabe this is the question i should have asked first) and if so are there any special considerations i should note?
Thanx
Ps. Will this work?( mabe this is the question i should have asked first) and if so are there any special considerations i should note?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Adjusted points to 100
Give me your address or email me.
Gerd.Brauner@GermanParcel. de
I don't need your payment for shipping I worked at a Parcel Service :-) .
regards gerd
Gerd.Brauner@GermanParcel.
I don't need your payment for shipping I worked at a Parcel Service :-) .
regards gerd
ASKER
I would be willing to pay for shipping and handleing for your efforts. ( within reason)
-eric