Unable to register service layer

NT 4.0 - At the time the computer boots the Error "Unable to register service layer" comes up and when you click OK the computer continues to run with apparently no problems.  How can I get rid of this problem?
SteveKingAsked:
Who is Participating?
 
jaakkolaConnect With a Mentor Commented:
You should check the EventLog and if the device causing the message is not necessary remove it. If you need the device (or service), remove it and re-install it. If it still doesn't work remove the device (or service) and clean registry from the device's part and re-install device (or service). Something like that might also happen if you have had some device a long ago and you have removed but you have forgotten to remove drivers for it.

Good Luck!
Mikko Jaakkola
0
 
portlandCommented:
Have you checked the Event Log to see if there's a corresponding entry that might give more details?
0
 
portlandCommented:
Sounds like good advice to me Mikko.  In fact we might have a similar problem on a server at work that keeps crashing/rebooting.  Then again, I think we may have multiple problems with that little bugger...  We'll find out more this weekend; I'm going to spend some quality time with it.  :-)
0
 
SteveKingAuthor Commented:
Thanks for the information.  I'll work on that today...
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.