pentax
asked on
Jumpers on NE2000 COmpatible
I've go an old NE2000 Compatible card ( I dunno if it it NetWare's)
I don't have any documentation on it, so I would like to know, what are the meanings of jumpers on it.
(Especcialy 8 jumpers with three pins - Ethernet/Cheapnet)
I don't have any documentation on it, so I would like to know, what are the meanings of jumpers on it.
(Especcialy 8 jumpers with three pins - Ethernet/Cheapnet)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I use coax cable with BNC connector. What setting should I set ?
There is A red LED on the back. Does it mean that card is not configured properly ?
Can you explain the meaning of soe more jumpers on the card (like ROM, ...)
There is A red LED on the back. Does it mean that card is not configured properly ?
Can you explain the meaning of soe more jumpers on the card (like ROM, ...)
ASKER
I use coax cable with BNC connector. What setting should I set ?
There is A red LED on the back. Does it mean that card is not configured properly ?
Can you explain the meaning of soe more jumpers on the card (like ROM, ...)
There is A red LED on the back. Does it mean that card is not configured properly ?
Can you explain the meaning of soe more jumpers on the card (like ROM, ...)
RG58 coax is Cheapnet, The leds can have any meaning whatsoever. Polly a RX/TX and a LINK led, in which case they wont do much at all with a RG58 cable.
ASKER