Brequest.exe & Win95
Posted on 1998-01-12
My "c:\windows\winstart.bat" has the "c:\windows\brequest.exe" line in it. When Win95 boots,
I see it load, without errors.
However, when I run Connectview (an application which
requires it) , it says that it couldn't initialize because
brequest.exe was not loaded.
I verify such by going to a dos window and typing
mem/c/p and see that brequest is indead not loaded.
I doubt that this is truely a Netware problem
Contents of CONFIG.SYS
rem Device=c:\windows\emm386.exe RAM
rem Install c:\windows\brequest.exe
Contents of AUTOEXEC.BAT
rem scandisk c:
lh doskey /insert
I have tried it without these TSRs. I have also tried it with a different Antivirus scanner. All results are the same.
PC is P133 with 64MB ram