Solved

Only read files

Posted on 1998-05-21
1
127 Views
Last Modified: 2010-04-06

HOw can i know when an file is an only reading file?

:) Thanks!
0
Comment
Question by:suetonio
1 Comment
 
LVL 1

Accepted Solution

by:
Socrates050697 earned 40 total points
ID: 1347100
use FileGetAttr as follows


  if (FileGetAttr('myfile.xxx') and faReadOnly)>0 then
    ShowMessage('is read only')
  else
    ShowMessage('not read only');



Socrates
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

Introduction The parallel port is a very commonly known port, it was widely used to connect a printer to the PC, if you look at the back of your computer, for those who don't have newer computers, there will be a port with 25 pins and a small print…
In my programming career I have only very rarely run into situations where operator overloading would be of any use in my work.  Normally those situations involved math with either overly large numbers (hundreds of thousands of digits or accuracy re…
It is a freely distributed piece of software for such tasks as photo retouching, image composition and image authoring. It works on many operating systems, in many languages.
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

705 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

18 Experts available now in Live!

Get 1:1 Help Now