gcassel
asked on
Form truncation after using Setup Wizard
I program on a Dell laptop with an active matrix screen. I recently completed an application, compiled it and it ran fine on the laptop. I then ran the Setup Wizard and copied the program setup to diskettes. After this I installed my program from the diskettes onto a "vanilla" desktop which only had Windows 95. The program installed and ran fine HOWEVER my forms lost some of the right and bottom sides. They were truncated off and I therefore lost some controls too. What did I do wrong?? Was thsi a funtion of going from the laptop to the desktop or do I need to incorporate code in my program which redraws the form when loading?
Thanks.
Thanks.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER