Solved

direct hyperterminal modem commands

Posted on 1998-10-13
3
308 Views
Last Modified: 2013-12-27
I was instructed by a support technician at Diamond Products to issue some commands to the modem using Hyperterminal. (HYPERTRM.EXE is what I used.) Unfortunately, I cannot seem to do this. The program keeps asking me for a phone number etc. and won't let me just type in some commands. How does one do this?
0
Comment
Question by:BobArnett
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 1

Accepted Solution

by:
palantyri earned 70 total points
ID: 1145111
here's what you need to do.  when you open hyperterminal, you get a wizard, give it a name and a fake phone #, make sure it shows your modem.  then it will ask you to dial, hit cancel.  you now have access to the modem to try the commands.  if you click file, go to properties, hit the settings tab, click the ascii setup button, you can choose to echo typed characters locally.  this will allow you to see what you type in.  then you can type whatever commands like ati3 or whatever that diamond wants you to do

jb
0
 

Author Comment

by:BobArnett
ID: 1145112
Just right, palantyri (jb). All went fine.
0
 
LVL 1

Expert Comment

by:palantyri
ID: 1145113
good to hear

jb
0

Featured Post

Visualize your virtual and backup environments

Create well-organized and polished visualizations of your virtual and backup environments when planning VMware vSphere, Microsoft Hyper-V or Veeam deployments. It helps you to gain better visibility and valuable business insights.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
vm nic duplex 1 84
6500 series with 2T sup - ios upgrade and restore config from usb how-to 1 75
Connect two buildings 6 62
Cisco 2960 unable to add SFP modules to device 9 131
Hello All, I have been training on Multicast for a while now and whenever I start the topic , I find out that my friends /  Colleagues mention that they do not know how to test Multicast Joins. As most of the multicast would be video traffic and …
Hi there, This article summarizes what you need if you are going to set up your home or small business Network Attached Storage (NAS) to be accessible from the internet. Of course there are configuration differences based on your NAS or router ma…

737 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question