aroot
asked on
jamicom mother bd jumper settings
I have a Jamicon 486 mother bd. ID info on bd is (LS-486e,
T5 94v-0 5647, Rev c2, SIS chip set,s/n 4428376). I need a
list of the jumper settings or a manual for this bd. I would
appreciate any assistance you could give me in locating this
information
T5 94v-0 5647, Rev c2, SIS chip set,s/n 4428376). I need a
list of the jumper settings or a manual for this bd. I would
appreciate any assistance you could give me in locating this
information
ASKER
The only manuals at the above location at Jamicon were for Pentium mother bds not 486
mother bds. As additional info the layout is as follows.
ISA SLOT
ISA SLOT
ISA SLOT
2-COMM & 1-PTR PORT
VR JUMPERS PCI SLOT
CPU,CLK,MULT,ETC PCI SLOT
JUMPERS PCI SLOT
CPU CHIP FLOPPY PORT
2ND IDE PORT
1ST IDE PORT
72 PIN SIMM #1
72 PIN SIMM #2
72 PIN SIMM #3
72 PIN SIMM #4
Hope this helps a little more.
mother bds. As additional info the layout is as follows.
ISA SLOT
ISA SLOT
ISA SLOT
2-COMM & 1-PTR PORT
VR JUMPERS PCI SLOT
CPU,CLK,MULT,ETC PCI SLOT
JUMPERS PCI SLOT
CPU CHIP FLOPPY PORT
2ND IDE PORT
1ST IDE PORT
72 PIN SIMM #1
72 PIN SIMM #2
72 PIN SIMM #3
72 PIN SIMM #4
Hope this helps a little more.
Anything silkscreened on the MB near the jumpers?
M
M
ASKER
JP5 THRU JP13 (YELLOW JUMPERS)
W1 (NO JUMPER INSTALLED)
JP18 (VR JUMPERS-RED)
JP19 (BLACK JUMPER)
REV: C2
NO SILK SCREEN JUMPER LAYOUT PRINTED ON BD.
ONLY ITEMS PRINTED ON BD EITHER SIDE WAS
STATED IN ORIGINAL QUESTION.
W1 (NO JUMPER INSTALLED)
JP18 (VR JUMPERS-RED)
JP19 (BLACK JUMPER)
REV: C2
NO SILK SCREEN JUMPER LAYOUT PRINTED ON BD.
ONLY ITEMS PRINTED ON BD EITHER SIDE WAS
STATED IN ORIGINAL QUESTION.
ASKER
Adjusted points to 30
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I sent E-Mail to Jamicon support and hopefully they will respond soon.(a day or two)
My supplier sent me a fax of the SIS 80486 but the jumpers were layed out wrong and
the JPxx numbers also were not the same.(Mine were JP5 to JP19). the fax showed JP7 to JP32. Thanks for your help.
My supplier sent me a fax of the SIS 80486 but the jumpers were layed out wrong and
the JPxx numbers also were not the same.(Mine were JP5 to JP19). the fax showed JP7 to JP32. Thanks for your help.
You'll need a program to read PDF files,
i.e., Adobe Acrobat Reader.