Solved

ms exchange/nt server gateway to unix server

Posted on 1998-10-28
3
230 Views
Last Modified: 2013-12-23
I want to set up a NT server with MS exchange on it but I want to connect this with my existing unix server how would i go about this? do i need a gateway service from MS??
0
Comment
Question by:will177
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 51

Accepted Solution

by:
ahoffmann earned 50 total points
ID: 1582532
Install Intenet Message Service in your Exchange server.
This allows to send and receive mails via SMTP for Exchange.

If you just want to pop your mails from Unix server, you must add the Internet Mail Service in Outlook and set it up as pop client.
This must be done at each client.
0
 

Expert Comment

by:alucero
ID: 1582533
If we want to "pop" emails from Unix server to Exchange..what configuartions must be done to setup the unix server ( running Solaris in this case).

thanks in advance
0
 
LVL 51

Expert Comment

by:ahoffmann
ID: 1582534
Exchange server cannot "pop" :-(
I'm not shure about the Exchange client, but Outlook can.
On Solaris you need to enable port 110, Solaris usually comes with a preset popd on this port.
0

Featured Post

Prepare for your VMware VCP6-DCV exam.

Josh Coen and Jason Langer have prepared the latest edition of VCP study guide. Both authors have been working in the IT field for more than a decade, and both hold VMware certifications. This 163-page guide covers all 10 of the exam blueprint sections.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

When it comes to security, there are always trade-offs between security and convenience/ease of administration. This article examines some of the main pros and cons of using key authentication vs password authentication for hosting an SFTP server.
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…
Suggested Courses
Course of the Month5 days, 1 hour left to enroll

635 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question