Link to home
Start Free TrialLog in
Avatar of scottguy
scottguy

asked on

IPX with RIP NWLink using FPNW on NT server

NT server, 2 LAN cards, 1 is Network #1 the other is Network #2.  Both work correctly.  IPX works correctly on network 1 and clients can log into network 2 but IPX signalling cannot be used on LAN 2.  It was suggested that RIP must be installed.  When RIP is installed and enabled and the server is rebooted the Event log says that it was unable to load RIP due to an 'incorrect parameter.'  The only 'parameter' I saw for the RIP service was enable or disable??
ASKER CERTIFIED SOLUTION
Avatar of Triggy
Triggy

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of scottguy
scottguy

ASKER

Although I haven't put Triggy's answer 'to the test' as of yet, it does sound like it will work.  After all, isn't the answer to 90% of all tech support questions "re-install" or "re-boot"?? :-)  Seriously, this does sound like an extremely viable solution and, if you'd like, I'll be happy to let you know how it worked out.