Solved

Cyclades problem

Posted on 1998-12-15
4
189 Views
Last Modified: 2010-03-18
Hi all

I have a Cyclades Cyclom 16 YeP multiport board and 6 US Robotics modems with RedHat 5.2 linux box.
I have made the following steps:
-board and all hardware installation
-BIOS have assigned IRQ 10 to the Cyclades
-I have made ttyCx and cubx in /dev with mkcyc from Cyclades disk
-I have put all  /bin/setserial /dev/cubx auto_irq spd_vhi in /etc/rc.d/rc/local
So, why can't I to initialize my modems with minicom or pppd (they and all the linux box stop responding)

If someone can help me, please send some words
Thanx
Maria   doarme@hotmail.com
0
Comment
Question by:scandic
4 Comments
 
LVL 2

Expert Comment

by:canani
ID: 1587904
Don't use auto_irq

/bin/setserial /dev/cubx spd_vhi


0
 

Author Comment

by:scandic
ID: 1587905
Hi canani!

First I want to thank you for your interest.
OK...
I have work around in this problem and now I have the solution...
But the solutions aren’t yours....
The cyclades board is working fine with "/bin/setserial /dev/cubx auto_irq spd_vhi"...
My problem was from a conflict between motherboard and the PCI Cyclades Card....
But I will pay you for your interest..
Excuse my poor English...


Maria

0
 

Expert Comment

by:kkennedy77
ID: 1587906
I had the same problem with a cyclom 16 pci, dont set these things to irq 10!!!
0
 

Accepted Solution

by:
vladoz earned 170 total points
ID: 1587907
try cat /proc/interrupts and see isn't there anyone else holding the interrupt. If not cat /proc/pci and see there isn't there PCI component holding that interrupt.
This is definitely IRQ sharing problem.


0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
Sending a Secure fax is easy with eFax Corporate (http://www.enterprise.efax.com). First, Just open a new email message.  In the To field, type your recipient's fax number @efaxsend.com. You can even send a secure international fax — just include t…
This demo shows you how to set up the containerized NetScaler CPX with NetScaler Management and Analytics System in a non-routable Mesos/Marathon environment for use with Micro-Services applications.

707 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

18 Experts available now in Live!

Get 1:1 Help Now