Solved

internal modem installation in Solaris2.7

Posted on 1999-01-05
1
163 Views
Last Modified: 2010-04-21
I have no experience with Unix. I'm a ROOKIE  

I'm trying intall a internal modem in Solaris2.7 x86
what commands should I use and how should I proceed at installing this modem.

Thanks very much for being patience..
0
Comment
Question by:ovillaci
1 Comment
 

Accepted Solution

by:
sun4u earned 50 total points
ID: 2008642
You really don't need to set it up like you would in windows.
As long as it is plugged in, it should work. The device should be either:

/dev/cua/a - "com 1 in dos"
or
/dev/cua/b - "com 2 in dos"

To check to see if its working use a command called tip.
So if your modem is on com2 you would type:

# tip /dev/cua/b

You can then use command like atdt to dial a remote system.
To set your baud rate look at the tip man page.

# man tip
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

Suggested Solutions

This tech tip describes how to install the Solaris Operating System from a tape backup that was created using the Solaris flash archive utility. I have used this procedure on the Solaris 8 and 9 OS, and it shoudl also work well on the Solaris 10 rel…
Introduction Regular patching is part of a system administrator's tasks. However, many patches require that the system be in single-user mode before they can be installed. A cluster patch in particular can take quite a while to apply if the machine…
Learn how to find files with the shell using the find and locate commands. Use locate to find a needle in a haystack.: With locate, check if the file still exists.: Use find to get the actual location of the file.:
In a previous video, we went over how to export a DynamoDB table into Amazon S3.  In this video, we show how to load the export from S3 into a DynamoDB table.

707 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

17 Experts available now in Live!

Get 1:1 Help Now