Rayzor022198
asked on
New Jamcon Motherboard, No manual!!!!!!!!!!!!!!!!!!!!!!!!
Can anyone please tell me the jumper settings for the jamcon motherboard KM646B, I have purchased the Board, a Celeron 300A chip, and memory, but I have no Motherboard manual, a swift succesful response guarentees lots of points!!!!!!!!
Cheers
Rayzor
Cheers
Rayzor
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Seems ok, let me give it a try and I'll give you the points when it works!!!!!
Rayzor,
I think the correct settings for your CPU should be to enable 66MHz clock frequency, with 4.5 multiplier.
As you may know, that CPU is said to be quite over-clockable. Many run at 450MHz or more. If you are interested, details and links for more info can be found at the following website:
http://www.3dhardware.net/features/slot1voltage/
Regards,
Ralph
I think the correct settings for your CPU should be to enable 66MHz clock frequency, with 4.5 multiplier.
As you may know, that CPU is said to be quite over-clockable. Many run at 450MHz or more. If you are interested, details and links for more info can be found at the following website:
http://www.3dhardware.net/features/slot1voltage/
Regards,
Ralph
Are you having problems with this?
ASKER
I got a copy of the manual, but your comments helped, and have given me an idea on overclocking, if I need assistance, I'll address the next question to you!
Cheers
Rayzor
Cheers
Rayzor
Hmmmmm,
What would it take to get an "A" grade?
(I don't know if I could answer the next question in 7 minutes) :)
Have fun with it!
Regards,
Ralph
What would it take to get an "A" grade?
(I don't know if I could answer the next question in 7 minutes) :)
Have fun with it!
Regards,
Ralph
ASKER
I got a full manual, not just your reference to the online one, I got a photocopy of the actual manual that should have been in the box!!!
You'd have got an A grade if you could have sent me the manual snail mail!!!!*LOL*
Cheers again
Rayzor
You'd have got an A grade if you could have sent me the manual snail mail!!!!*LOL*
Cheers again
Rayzor
Okay. (I just couldn't find one.....)
I had hoped the jumper diagram would help.
Did you have any luck with overclocking the CPU?
There's lots more info available about O/C if you want it. (Let me know)
Ralph
I had hoped the jumper diagram would help.
Did you have any luck with overclocking the CPU?
There's lots more info available about O/C if you want it. (Let me know)
Ralph
ASKER
The jumper settings did help, we just had a CPU problem, it had dirty contacts, and wasn't making a proper connection!
I've not tried the overclocking yet, I am interested, but unless I know exactly what pins to cover I'm not overly keen on doing anything!
I don't suppose you know any specific instructions for my Motherboard??
Cheers
Rayzor
I've not tried the overclocking yet, I am interested, but unless I know exactly what pins to cover I'm not overly keen on doing anything!
I don't suppose you know any specific instructions for my Motherboard??
Cheers
Rayzor
Sorry, but I haven't seen that one before.
Ralph
Ralph
Here's the one you need:
http://www.jamicon.nl/manual/man646b.htm
Let me know if you need more.
Regards,
Ralph