Want to protect your cyber security and still get fast solutions? Ask a secure question today.Go Premium

x
  • Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 184
  • Last Modified:

Modem connection problem

I just purchased a new Accelerator Pro 56000 Internal Voice Fax Modem. My Operating Systems are a dual boot WIN95/WINNT 4.0. I connect to the Internet through WIN95. I had a 33.6 modem which worked fine, but was to slow. The new modems problem is when I try to connect to My ISP you hear a dial tone, but before it starts to dial, I hear a click, then a error message pops up (No Dial Tone, Check...etc). I had to re-install my 33.6 to go on line. Any suggestions? I think it might be a faulty modem because the old one works fine after I re-installed it(33.6)
0
BERNARD
Asked:
BERNARD
1 Solution
 
rbrCommented:
Change your modem settings to ignore dial tone.
0
 
BERNARDAuthor Commented:
I'm going to give the points to rbr. Though someone else touched MY COMPUTER and cause more problems which wouldn't allow even my 33.6 modem to connect. I re-installed the 56k from scratch, step by step and it works?? I'm not going to question it though

                                                       Thanks

 

0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Tackle projects and never again get stuck behind a technical roadblock.
Join Now