Solved

vvinesd.386

Posted on 1999-01-23
2
186 Views
Last Modified: 2013-12-28
I get vvinesd.386 file is missing when i boot up
0
Comment
Question by:joefjr
2 Comments
 

Expert Comment

by:neptune26
ID: 1652739
What operating system are you using?  Did this start after you installed some new software?
0
 
LVL 25

Accepted Solution

by:
dew_associates earned 10 total points
ID: 1652740
Hi Joe,

This problem is not uncommon during upgrades, especially when there may be some network components and protocols involved. Try this, it should help you.

This problem can occur if an upgrade to Windows 95 or Windows 98 detected the Banyan VINES network client but the Banyan VINES network client was not installed. This is may be caused by a previous installation of the Banyan VINES network client that left the following information in the Protocol.ini file:
 
   [BAN$VINES]
   DriverName=ndisban$
 
   [NDISBAN$]
   DriverName=NDISBAN$
 
Setup uses the Protocol.ini file to determine which 16-bit clients to install during an upgrade. When the preceding sections exist in the Protocol.ini file Setup automatically installs the Banyan VINES network client.
 
To resolve this, use the following steps:
 
1. Use the System Configuration utility (Msconfig.exe) to disable the "Device=c:\windows\vvinesd.386" line in the [386Enh] section of the System.ini file if it exists.
 
2. Restart your computer. If you receive the error message again, continue to step 3.
 
3. Click Start, point to Settings, click Control Panel, and then double-click Network.
 
4. If any of the following network components are present, remove them:
 
    - Banyan DOS/Windows 3.1 Client
    - Banyan VINES ethernet Protocol
    - Banyan VINES token ring Protocol

To do so, click a component, and then click Remove. Repeat this until all of these components are removed.
 
5. Click OK, and then click Yes. If you receive the error message again, continue to step 6.

NOTE: Using Registry Editor incorrectly can cause serious problems that may require you to reinstall your operating system.For information about how to edit the registry, view the "Changing Keys And Values" Help topic in Registry Editor (Regedit.exe) or the "Add and Delete Information in the Registry" and "Edit Registry Data" Help topics in Regedt32.exe. Note that you should back up the registry before you edit it.
 
6. Use Registry Editor to delete the vvinesd value under the following registry key and then restart your computer:

HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\VXD\

If you need to gain access to resources on a Banyan network, you
should reinstall the Banyan client. To install the 16-bit client, see the following article in the Microsoft Knowledge Base: Q123877 How to Set Up Banyan VINES in Windows 98
 
There is a 32-bit Banyan client, but Microsoft does not provide support for this client.

If there are any questions, please ask!
Dennis
0

Featured Post

Don't lose your head updating email signatures!

Do your end users still have the wrong email signature? Do email signature updates bore you or fill you with a sense of dread? You can make this a whole lot easier on yourself by trusting an Exclaimer email signature management solution. Over 50 million users do...so should you!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

If you get continual lockouts after changing your Active Directory password, there are several possible reasons.  Two of the most common are using other devices to access your email and stored passwords in the credential manager of windows.
Join Greg Farro and Ethan Banks from Packet Pushers (http://packetpushers.net/podcast/podcasts/pq-show-93-smart-network-monitoring-paessler-sponsored/) and Greg Ross from Paessler (https://www.paessler.com/prtg) for a discussion about smart network …
Windows 8 comes with a dramatically different user interface known as Metro. Notably missing from the new interface is a Start button and Start Menu. Many users do not like it, much preferring the interface of earlier versions — Windows 7, Windows X…
With the advent of Windows 10, Microsoft is pushing a Get Windows 10 icon into the notification area (system tray) of qualifying computers. There are many reasons for wanting to remove this icon. This two-part Experts Exchange video Micro Tutorial s…

867 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

22 Experts available now in Live!

Get 1:1 Help Now