fahlis
asked on
Problems detecting printer port in Redhat 6.1,after installing Lexmark 5700 driver!
Hi,
I have a Lexmark 5700 printer,which can be installed with a custom ghostscript,well I think I´ve
mangaged to install the printer,cause I can see it
when I run printtool-add printer,but before I get into printtool it says "auto detection found the following :
/dev/lp0 not detected
/dev/lp1 not detected
/dev/lp2 not detected
I had this working when Redhat 6 was installed,so
I know it should work,but I don´t know how to set it up correct,please help me.
/Tony
I have a Lexmark 5700 printer,which can be installed with a custom ghostscript,well I think I´ve
mangaged to install the printer,cause I can see it
when I run printtool-add printer,but before I get into printtool it says "auto detection found the following :
/dev/lp0 not detected
/dev/lp1 not detected
/dev/lp2 not detected
I had this working when Redhat 6 was installed,so
I know it should work,but I don´t know how to set it up correct,please help me.
/Tony
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks,worked like charm,get your well earned points.
/Tony