PCMCIA Network card

Posted on 1999-12-30
Medium Priority
Last Modified: 2010-03-18
Anybody know how to get a NETGEAR model FA410tx 10/100 pcmcia card to work. I am using mandrake 6.0. I have no problems getting a pcmcia modem to work but can not get the network card to be recognized.
Question by:doublej103
  • 2

Expert Comment

ID: 2316187
You need the pcnet_cs driver for that.  see:


That card is listed under supported 10/100 adapters in the second section.

Also, I think you need to have card services installed, but if you got the modem to work, you should be ok.


Accepted Solution

biard earned 200 total points
ID: 2321021
Any luck.  Did that work or what?

Featured Post

Get your problem seen by more experts

Be seen. Boost your question’s priority for more expert views and faster solutions

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
If you're a developer or IT admin, you’re probably tasked with managing multiple websites, servers, applications, and levels of security on a daily basis. While this can be extremely time consuming, it can also be frustrating when systems aren't wor…
In this video I will demonstrate how to set up Nine, which I now consider the best alternative email app to Touchdown.
Suggested Courses

592 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question