Solved

Installing Graphic Card

Posted on 2000-02-24
2
193 Views
Last Modified: 2013-12-15
I have a VideoLogic Grafixstar Apocalypse 5D Power VR Graphic Card. It's not supported in Linux Suse 6.0. Does someone have a packet that upgrades Linux setup so that it  recognizes this or any other solution.
Thanks.
0
Comment
Question by:arno_webmaster
2 Comments
 
LVL 2

Expert Comment

by:EatEmAndSmile
ID: 2564955
Check out for the latest XFree86 version at www.xfree86.org and watch for the list of supported adapters. If it's there, upgrade your XFree86.
0
 

Accepted Solution

by:
canUCme earned 50 total points
ID: 2582606
I'm using red hat 6.1..I had same kinda
problems when I was using red hat 6.0. It didn't regonize my riva TNT2 card..I did download latest X server from Xfree86..

Here's the files
ftp://ftp.xfree86.org/pub/XFree86/3.3.6/binaries/Linux-ix86-glibc21/

Here's the installation notes..
http://www.uni-paderborn.de/mirrors/xfree86/3.3.6/RELNOTES.html


Here's list of supported video cards
http://www.uni-paderborn.de/mirrors/xfree86/cardlist.html


installation is basicly


tar -xvf tgz files

then run
xf86config
It configures X server..

Be sure that you set Right Vertical
and horisontal frequenzies or else your monitor might ZAP.

0

Featured Post

6 Surprising Benefits of Threat Intelligence

All sorts of threat intelligence is available on the web. Intelligence you can learn from, and use to anticipate and prepare for future attacks.

Join & Write a Comment

Over the last ten+ years I have seen Linux configuration tools come and go. In the early days there was the tried-and-true, all-powerful linuxconf that many thought would remain the one and only Linux configuration tool until the end of times. Well,…
Introduction We as admins face situation where we need to redirect websites to another. This may be required as a part of an upgrade keeping the old URL but website should be served from new URL. This document would brief you on different ways ca…
Learn how to find files with the shell using the find and locate commands. Use locate to find a needle in a haystack.: With locate, check if the file still exists.: Use find to get the actual location of the file.:
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

708 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

15 Experts available now in Live!

Get 1:1 Help Now