Solved

Installing a HP-CDRW under RedHat 6.1

Posted on 2000-03-15
3
278 Views
Last Modified: 2013-12-15
How do I install my HP7500 (IDE) CDRW under RedHat 6.1 ?
I understood I need to make it mounted as a scsi CDR. How do I do this ?
When I changed the cdrom mount line in the fstab to:
/dev/scd0 /mnt/cdrom ...
it wasn't mounted at all.
What should I do ?
0
Comment
Question by:ygal02
  • 2
3 Comments
 
LVL 3

Author Comment

by:ygal02
ID: 2629485
Adjusted points from 50 to 100
0
 
LVL 3

Author Comment

by:ygal02
ID: 2632862
Adjusted points from 100 to 150
0
 
LVL 2

Accepted Solution

by:
mapc earned 150 total points
ID: 2633173
You need to enable "IDE SCSI EMULATION"
which is under block devices (Assuming 2.2.x),then, your hp cdr will appear to the software as a scsi device, and you'll be able to use cdrecord and similar tools.
After doing that, I believe  that you'll be able to mount it like /dev/scd0 , but , check dmesg after reboot.
Again, if I'm not mistaken, you'll need also to enable in SCSI section:
SCSI  CDROM
SCSI Generic support.
perhaps even SCSI DISK support.
Read the help for "IDE-SCSI emulation" , it says what is needed.
0

Featured Post

Complete VMware vSphere® ESX(i) & Hyper-V Backup

Capture your entire system, including the host, with patented disk imaging integrated with VMware VADP / Microsoft VSS and RCT. RTOs is as low as 15 seconds with Acronis Active Restore™. You can enjoy unlimited P2V/V2V migrations from any source (even from a different hypervisor)

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Using 'screen' for session sharing, The Simple Edition Step 1: user starts session with command: screen Step 2: other user (logged in with same user account) connects with command: screen -x Done. Both users are connected to the same CLI sessio…
Linux users are sometimes dumbfounded by the severe lack of documentation on a topic. Sometimes, the documentation is copious, but other times, you end up with some obscure "it varies depending on your distribution" over and over when searching for …
Learn how to navigate the file tree with the shell. Use pwd to print the current working directory: Use ls to list a directory's contents: Use cd to change to a new directory: Use wildcards instead of typing out long directory names: Use ../ to move…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

829 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question