Link to home
Start Free TrialLog in
Avatar of tengle
tengle

asked on

PcChips M599lmr motherboard

Installed M599lmr ATX all-in-one MB w/preinstalled Cyrix 300 from working pull. New case/power supply and ram. MB powers on, but no video or beeps. Tried clearing CMOS, RAM from working system, disconnecting all devices.
Avatar of sorgie
sorgie
Flag of United States of America image

I assume you hear power supply running?
If not check all power connections.

Check all you cards to be sure all seated.

Try disabling everything except mem and video see what happens
ASKER CERTIFIED SOLUTION
Avatar of 10Bad_bob
10Bad_bob

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of RoadWarrior
RoadWarrior

The supplier installed the CPU?

Most suppliers caution that they stick the chip in the socket but all the jumper setting is up to you, so did you set or check the jumpers?

What memory configuration do you have? I believe the Cyrix 300 is the same as the old pentiums, in that they require memory chips in PAIRS... i.e. two 16 meg EDO chips, or two 8 meg EDO chips, etc. You can't just run one 32 meg chip, or one 16 meg chip, or mix and match.

TIm
Avatar of tengle

ASKER

Ram wasn't seated. Had to remove MB and push Ram in.