bantams
asked on
How to remove/stop UDFReadr error message from start up
We have just bought a new PC - Pentium III 550Mhz with Win NT 4 WS SP4 pre-installed, i have installed the network components on the pc, and connected to the network ok.
however on boot-up, I am getting the error message :-
Event ID 7026
The following boot-start or system-start driver(s) failed to load:
UdfReadr.
question is, how do i stop this message from appearing, i am assuming it was used as part of the unattended installation carried out at the manufacturers, and is no longer needed?
your early responses would be appreciated.
however on boot-up, I am getting the error message :-
Event ID 7026
The following boot-start or system-start driver(s) failed to load:
UdfReadr.
question is, how do i stop this message from appearing, i am assuming it was used as part of the unattended installation carried out at the manufacturers, and is no longer needed?
your early responses would be appreciated.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks, looked in Services, nothing there, looked in the startup folders and nothing there either, so looked through the registry, and found a few entries, so took a backup of the registry in case of a balls up, and then deleted the last of the keys, and it worked a treat!
ASKER
just does it on this PC