Solved

Setting up modem in Redhat Linux 6.1

Posted on 2000-05-04
2
199 Views
Last Modified: 2010-03-18
I am using Redhat Linux 6.1.I chose custom setup previously and excluded networking.I like to know exactly which packages are needed to install to connect to internet via Linux and via modem.
  Eventually I have no additional network card.Only I have a 56 KBps D-Link external modem that supports both K56flex and V.90 standards.
  please specify the exact steps to connect to internet (including configuring the modem).
  So,pleeeeeze help me.Looking forward...
0
Comment
Question by:netwiz
2 Comments
 

Accepted Solution

by:
openguin earned 100 total points
ID: 2779487
Netwiz,

I recommend reading the /usr/doc/HOWTOs for PPP and NET-3.  All your answers are there.  Additionally, are you going to masquerade other machines or have a single dial-up?  In any event, the PPP and DIALD packages are essential.  I also recommend implementing one phase at a time (i.e. PPP, then IPCHAINS, then, etc.).  While you're at it, review compiling your kernel.  I personally like KERMIT to send AT commands and test my modem/connection;  SEYON will also work.  I can't provide the exact steps because the situation isn't exact.  You should also consider a majordomo list server.  No frills but a very smart crew awaits your questions 24x7.

Linux:
   Think
   Read
   Do
Loop Linux
0
 

Author Comment

by:netwiz
ID: 2850933
I was out of station.Give me time to do all the above mentioned things first.I want more suggestions as well.
0

Featured Post

Why You Should Analyze Threat Actor TTPs

After years of analyzing threat actor behavior, it’s become clear that at any given time there are specific tactics, techniques, and procedures (TTPs) that are particularly prevalent. By analyzing and understanding these TTPs, you can dramatically enhance your security program.

Join & Write a Comment

Suggested Solutions

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

746 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

13 Experts available now in Live!

Get 1:1 Help Now