Router question

Aksed this question in the routers area but no one could answer it.  I just installed a VPN module in a 1750 series cisco router.  I want to know whether or not I properly istalled it.  Is there a command I can issue to see?  Show controllers doesn't show anything?  What can I do?
Also: if anyone knows the best way to install the VPN software for the cisco 1750 or any GUI utilities I could use that would be great.  HELP!!
SilasAsked:
Who is Participating?
 
jkline73Connect With a Mentor Commented:
usually "sh ver" would show you whats installed on the router.

Example:  This is my 2621.
router# sh ver
Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.0(5)T1,  RELEASE SOFTWARE (fc1)Copyright (c) 1986-1999 by cisco Systems, Inc.Compiled Tue 17-Aug-99 13:57 by cmong Image text-base: 0x80008088, data-base: 0x8072C5D4

ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)

TTA2600 uptime is 2 weeks, 6 days, 21 hours, 3 minutes System returned to ROM by reload System image file is "flash:c2600-i-mz.120-5.T1"

cisco 2621 (MPC860) processor (revision 0x102) with 20480K/4096K bytes of memory. Processor board ID JAB040701VQ (161593414)M860 processor: part number 0, mask 49 Bridging software.
X.25 software, Version 3.0.0.
******** Modules ************
2 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
******** Modules ************
32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read/Write)

Hope this helps..

Configuration register is 0x2102
0
 
barttCommented:
I believe that the command
>show running-config

Shows al the modules that are running on your router

Bartt
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.