Borland C++3.0/Quick Reports

My application uses Borland C++ builder 3.0 and Quick reports 2.0. recently i upgraded to 3.0 and build the application. While running it i got an error messagebox titled <my app title> "Entry point not found". The message is "The procedure entry point @Qr2const@initialisation$qqrv could not be located in the dynamic link library qrptc43.bpl" I had ensured that the new quick reports libraries are in the runtile libraries path.. Where am i wrong? Please assist as  early as possible

Thanks in advance.
Who is Participating?
AlexVirochovskyConnect With a Mentor Commented:
Check out creation's time of "qrptc43.bpl" .
Is this file belongs to 3-d version?
This is easy detect by creation's time:
usually all new files are same time.
If it is old(as I think), simple try install
3-d version again.
Look for multiple .bpl files. In most cases your project still points to
your old bpl while updates are in your new bpl-file. So the entry-point
isn't found in your old bpl because it just isn't there. Take a look at your
project directories and i'm sure you will find the problem.

karthik1979Author Commented:
I had checked it out..but still the same problem persists...:-(
karthik1979Author Commented:
I recompiled the 2 bpk files in the qrdsgn2 dir and it worked fine..thanks.
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.