Solved

Cisco Content Services Switch 11152: cannot upgrade CSS software image

Posted on 2002-07-03
3
469 Views
Last Modified: 2012-05-04
I am having problems upgrading the software image on a Cisco content services switch 11152.  

The switch is currently running version 5.02 build 3

  CSS11150(config)# version
  Version:               ap0502003 (5.02 Build 3)
  Flash (Locked):        4.01 Build 32
  Flash (Operational):   5.02 Build 3
  Type:                  PRIMARY
  Licensed Cmd Set(s):   Standard Feature Set

I have the new image (sg0510001.adi-gz, downloaded from Cicso website) on an FTP server.  I am following instructions in Cisco's document "Upgrading Your CSS Software" (http://www.cisco.com/univercd/cc/td/doc/product/webscale/css/css_510/admgd/upgrade.htm).  When I try to upgrade the image using the upgrade script, the script bombs with the following message "Error in script playback line:597".  

When I try the upgrade using the manual method "Manually Upgrading the CSS", I can transfer the file using FTP, and unpack it.  I then isue the command: primary boot-file sg0510001, and get "Filename not present on disk".  

Any ideas?  

Thanks in advance.  



0
Comment
Question by:blowfish
  • 2
3 Comments
 
LVL 2

Author Comment

by:blowfish
ID: 7132145
I downloaded the wrong software image file.  

This image is for a CSS 11500, not a CSS 11150/11152.  The correct image is ap0503015.adi.gz.  

Regards,

--frankf
0
 

Accepted Solution

by:
hmkias earned 200 total points
ID: 7133499
b4 upgrading did u check the hardware namely Flash & boot  could go with  the new CSS.

Kias
0
 
LVL 2

Author Comment

by:blowfish
ID: 7137629
Thanks for your answer.  

I had printed the wrong maual, and downloaded the wrong software image.  

I now have the correct image file, and have successfully upgraded both of my CSS.  
0

Featured Post

Is Your Active Directory as Secure as You Think?

More than 75% of all records are compromised because of the loss or theft of a privileged credential. Experts have been exploring Active Directory infrastructure to identify key threats and establish best practices for keeping data safe. Attend this month’s webinar to learn more.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

914 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now