Link to home
Start Free TrialLog in
Avatar of mtgcpc
mtgcpc

asked on

Newbie Installation Question

I intstalled Redhat 7.1  workstation.  After the installation is complete, the machine reboots and all I get is an L prompt.  

Did the installation fail?  I didn't get any errors.

Thanks
Avatar of dorward
dorward

Looks like there is a problem with LILO (the boot loader software).


L: The first stage boot loader has been loaded and started, but it can't load the second stage boot loader. The two-digit error codes indicate the type of problem. (See also section ``Disk error codes''.) This condition usually indicates a media failure or a geometry mismatch (e.g. bad disk parameters).
ASKER CERTIFIED SOLUTION
Avatar of Gns
Gns

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial