command for vlan passthrough cisco 2924xl

edongskiu
edongskiu used Ask the Experts™
on
Hi,

I am in need of setting up a a new vlan that uses MAC(Media Access control). I am able to add the new vlan. I have a 2 VTP Server and 5 VTP client(all cisco 2924xl). My other vlan is working fine, all trunks are working fine. I made a test of connecting another switch to my existing switch and place a laptop with just ip, subnet and gateway. Also I created another port in my original cisco 2924xl that access the new vlan and place another laptop with ip,subnet and same gateway(above). I am able to ping each other's ip address. Then I configured another exsting switch from another room and use the command: config term, int fa0/16, switch access vlan 9. When I use sh vlan it displayed that vlan 9 is using port 16. I connected another laptop just to test but I couldn't ping any other IP that I have installed. I'll try later using IPX if it is possible. What am I missing in my config?

regards,
Eduard
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Les MooreSr. Systems Engineer
Top Expert 2008

Commented:
Did you configure a trunk port on the switch in addition to the VLAN 9 port?

Author

Commented:
No, I dont', our trunking I think is like for all(I did not configure our trunk) i look at the setup and the one written is:
             !
             interface Fastethernet1/1
             description ***Trunk to Hub ..***
             switchport trunk encapsulation dot1q
             switchport mode trunk
             !
can i insert: switchport access vlan in the trunking command?

or can i trunk my two vtp server so all other switch can use vlan9?

any advice on on-line tutorial for vlan or cisco?


thanks
Sr. Systems Engineer
Top Expert 2008
Commented:
Your VTP, VLANS, and Trunking all have to work together:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc3/sc/swgvlans.htm
Les MooreSr. Systems Engineer
Top Expert 2008

Commented:
G'day, edongskiu
No comment has been added lately (115 days), so it's time to clean up this TA.
I will leave a recommendation in the Cleanup topic area for this question:

RECOMMENDATION: Points awarded to: lrmoore

If you would like to keep this question open for more expert input, this cleanup effort will get it closer to the top of the list where it will get more visibility for the experts.

Please leave any comments here within 7 days.


PLEASE DO NOT ACCEPT THIS COMMENT AS AN ANSWER!

Thanks,

lrmoore
EE Cleanup Volunteer
---------------------
If you feel that your question was not properly addressed, or that none of the comments received were appropriate answers, please post a request in Community support (with a link to this page) to refund your points. http://www.experts-exchange.com/Community_Support/

Per recommendation, force-accepted.

Netminder
EE Admin

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial