siglinp
asked on
this is for lmoore
here ya go.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
hey get this when I put in the vpn stuff I can no longer telnet to the smtp on the dmz from the outside. Is this due to my messed up config?
ASKER
For lrmoore.
Never mind I was being stupid. It was working. I do have some oddities occuring. 1 the smtp server on the DMZ can accept incoming traffic from the inside and outside and can send traffic to the inside but can not send traffic outbound? nat (dmz) 1 0 0 0 0 ? Also the only thing out there is a smtp server on the DMZ. I am mapping from the address down to the port but when I scan the IP range it shows 21, 25 , 53 , 80, & 110 open. Any suggestions on that? I did do a deny statement which I thought would close ports? If I had my config I would send it to ya but I don't. On the bright side I am doing access-lists instead of conduits now.
Never mind I was being stupid. It was working. I do have some oddities occuring. 1 the smtp server on the DMZ can accept incoming traffic from the inside and outside and can send traffic to the inside but can not send traffic outbound? nat (dmz) 1 0 0 0 0 ? Also the only thing out there is a smtp server on the DMZ. I am mapping from the address down to the port but when I scan the IP range it shows 21, 25 , 53 , 80, & 110 open. Any suggestions on that? I did do a deny statement which I thought would close ports? If I had my config I would send it to ya but I don't. On the bright side I am doing access-lists instead of conduits now.
ASKER