rinkujain
asked on
Crystal report/Setup Problem????
I have made report in Crystal report 8.5 which has some chart into it and when i
was creating package in vb then that prompted me for :
-crystal
-u25store.dll
-u25total.dll
u2Lbar.dll
but i had not find that in my computer so made setup by ignoring this files
now when i deploy this on user m/c then my project was running fine but in
reports it is not showing charts but show other data .........
so help me out that what shd i do that chart also start coming in
reports?????
was creating package in vb then that prompted me for :
-crystal
-u25store.dll
-u25total.dll
u2Lbar.dll
but i had not find that in my computer so made setup by ignoring this files
now when i deploy this on user m/c then my project was running fine but in
reports it is not showing charts but show other data .........
so help me out that what shd i do that chart also start coming in
reports?????
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Overcome By Events.
I suspect the CR6 dlls may not work.
Let me know if you need anything more.
mlmcc
I suspect the CR6 dlls may not work.
Let me know if you need anything more.
mlmcc
ASKER
hello mlmcc
sorry for being late,
actually you were right that i can ignore these dll because when i tried to register u2lbar.dll ,it gave me error like 'entry point for it can't be found' and so my problem is still same as before
sorry for being late,
actually you were right that i can ignore these dll because when i tried to register u2lbar.dll ,it gave me error like 'entry point for it can't be found' and so my problem is still same as before
ASKER
still my problem is not solve but i am giving you points as you have given me some direction.
Thx
Rinku
Thx
Rinku
ASKER
What is OBE?
ya i had made setup without these files but chart has not shown ,so i require these files and what i knew till now is these files are present in CR 6 and so by copying these files from there and then make setup will resolve problem
hope it may work for me
any suggestion..........