timns
asked on
COM into DCOM
I have a COM object which was created a long time ago which I would now like to modify so I can run it on a remote PC. Does anyone have a nice succint set of steps which need to be followed to turn an in-proc .dll into a DCOM object?
i think u can register it;just like install a com+ object!of course,your system is 2000.good luck!
ASKER
If only it were that simple. I did not manage to get that going at all.
In the end I created a new application project, a new automation object, then imported all the existing COM code over and re-created the typelib entries.
A chore, but it works.
Now go ahead and break my heart by telling my how easy it could have been ;-)
In the end I created a new application project, a new automation object, then imported all the existing COM code over and re-created the typelib entries.
A chore, but it works.
Now go ahead and break my heart by telling my how easy it could have been ;-)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
timns:
This old question needs to be finalized -- accept an answer, split points, or get a refund. For information on your options, please click here-> http:/help/closing.jsp#1
EXPERTS:
Post your closing recommendations! No comment means you don't care.
This old question needs to be finalized -- accept an answer, split points, or get a refund. For information on your options, please click here-> http:/help/closing.jsp#1
EXPERTS:
Post your closing recommendations! No comment means you don't care.