Solved

VPN Oracle connection

Posted on 2003-10-21
2
922 Views
Last Modified: 2012-05-04
Does anyone know if a VPN connection between a Cisco 1700 and a Cisco PIX 515 would cause a problem for an Oracle database connection. Like does the VPN time out after a couple minutes then come back alive after it is used? We have Oracle custom apps running at remote branches and it "rolls back" (drops connection) a couple times a day if it is left for more than 45 minutes. Just trying to see if it is a VPN issue or Oracle. The problem has yet to show up in the main office where the Oracle server is.
0
Comment
Question by:klause2
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 5

Accepted Solution

by:
vtobusman earned 250 total points
ID: 9591663

 what you are saying it sounds like it will be in the oracle somewhere because if a vpn connection is lost or reset for in activity you have to re-establish a connection it wont just connect again. and assuming you are doing the vpn from router to Pix firewall, it will keep the connection alive.
    Check the MTU on both the Firewall and the oracle connection try increasing it..
and see if that helps.
0
 

Author Comment

by:klause2
ID: 9608929
I think it is srtictly a Oracle issue. Still nto sure what it is ,but I'm am almost positive it is not a VPN issue. Thanks!
0

Featured Post

Business Impact of IT Communications

What are the business impacts of how well businesses communicate during an IT incident? Targeting, speed, and transparency all matter. Find out more in this infographic.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
configure ASA Vlan Interface 14 97
Home network with two AP's dropping WiFi connectivity 12 105
BGP prefix and routing 3 97
Site cannot be reached ONLY when connected to modem 18 54
New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

739 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question