Services not starting in NT4.0 server

LuisP
LuisP used Ask the Experts™
on
Hello all,

I have an NT4.0 server (a BDC), it has a problem with some services not starting. these services are setup to start automatically every time that the server boots. I have not made any changes to it.

The services are:

     jBASE License Server
     jBASE Telnetd Server
     Attunity Connect Daemon (IRPCD)

all of these services have the same error:     Error 0003: The system cannot find the path specified.

The error message says:

     Services
     Could not start the jBASE License Server service on \\SERVER NAME.
     Error 0003: The system cannot find the path specified.
     Services
     Could not start the jBASE Telnetd service on \\SERVER NAME.
     Error 0003: The system cannot find the path specified.
     Services
     Could not start the Attunity Connect Daemon (IRPCD) service on \\SERVER NAME.
     Error 0003: The system cannot find the path specified.

Thank you for any comments that you may have.

LuisP
Comment
Watch Question

Do more with

Expert Office
EXPERT OFFICE® is a registered trademark of EXPERTS EXCHANGE®
Commented:
Look in the registry:

HKLM/System/CurrentControlSet/Services/

and locate the service entries for the services you listed above. Click on the service entry, and look at the path key - see if the path exists (ie. if the file listed exists and is in the right spot)

Author

Commented:
Hello jammyPak,

I was able to start the jBASE Telnetd Service but not the jBASE License Server. Now the jBASE License Server has the following error message:

     Services
     Could not start the jBASE License Server service on \\SERVER NAME.
     Error 1067: The process terminated unexpectedly.

I have checked all the permissions and rights with no results.

Thank you,

LuisP
have you tried different accounts to start the service with or even a system account?


cheers

Author

Commented:
Yes, I have tried a couple of accounts, but nothing happens
LuisP

Commented:
My guess is that this may be an install/config issue with the Jbase software itself. You may want to see if they have a support forum or if you can email them directly.

They have a knowledge base here http://www.jbase.com/support/index.html
and they mention some patches as well...is there one you haven't installed?

Do more with

Expert Office
Submit tech questions to Ask the Experts™ at any time to receive solutions, advice, and new ideas from leading industry professionals.

Start 7-Day Free Trial