Solved

Cisco 3524 XL not loading image on boot up

Posted on 2003-10-28
1
564 Views
Last Modified: 2008-02-01
Here is the sceen dump from the boot process, And yes I did have a brown out...It hasnt worked since.
I did reload another image still with no success....TIA
Initializing Flash...
flashfs[0]: 2 files, 1 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 3612672
flashfs[0]: Bytes used: 1799680
flashfs[0]: Bytes available: 1812992
flashfs[0]: flashfs fsck took 3 seconds.
...done Initializing Flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
Loading "flash:c3500XL-c3h2s-mz-120.5-XP.bin"...flash:c3500XL-c3h2s-mz-120.5-XP.
bin: no such file or directory

Error loading "flash:c3500XL-c3h2s-mz-120.5-XP.bin"

Interrupt within 5 seconds to abort boot process.
Boot process failed...

The system is unable to boot automatically.  The BOOT
environment variable needs to be set to a bootable
image.

switch: DAMN!!!!!
0
Comment
Question by:kurzet
1 Comment
 
LVL 7

Accepted Solution

by:
NicBrey earned 125 total points
ID: 9639960
Your new flash image got corrupted with the TFTP transfer.
Here is a link to how you can recover from it....

http://www.cisco.com/en/US/products/hw/switches/ps607/products_tech_note09186a0080094955.shtml

Good luck...
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question