mmacdougall
asked on
Help with Routing and Remote Access
I had an issue with a network card on our server. I put a new one in and now I am getting some problems.
I know it has to do with Routing and Remote Access, namely the input filters.
Basically, I cannot connect from my pc via VPN to the server as I used to be able to, also we cannot connect to our staging server using cold fusion.
Fix, when I go into the input filters and add one that looks like the following, everything works fine, but our security is terrible.
SourceAddress|SourceMask|D estination Addres|Des tinationMa sk|Protoco l|SourcePo rt or Type|DestinationPort or Code
Any Any Any Any TCP Any Any
Thanks
I know it has to do with Routing and Remote Access, namely the input filters.
Basically, I cannot connect from my pc via VPN to the server as I used to be able to, also we cannot connect to our staging server using cold fusion.
Fix, when I go into the input filters and add one that looks like the following, everything works fine, but our security is terrible.
SourceAddress|SourceMask|D
Any Any Any Any TCP Any Any
Thanks
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
How do you have the current filters setup? To allow an entire network or just certain hosts? Can you post your filters (disguising IP addresses if they are public) and explain what you want accomplished?
ASKER