Solved

VPN/IP problem with 2 DSL Routers on Same Network

Posted on 2003-11-04
2
512 Views
Last Modified: 2010-04-17
Hello

The problem I have is 2 DSL routers on a 192.168.1.x scheme.
One is a Netopia 4541 handles email/web browsing etc.. ip is 192.168.1.1 it is also the default gateway for the clients.
Two is a Draytek 2600 handling VPN's ip 192.168.1.3.

Problem when making a VPN LAN2LAN connection to the Draytek, vpn appears to connect fine but cannot ping any of the client on the network.
I have changed a client's default gateway to .3 and I get a response to a ping.

Netopia 2 Netopia VPN works fine can see all of network.
Draytek 2 Draytek VPN appears to work but cannot see Network on the Default Gateway 192.168.1.1.


Andy
0
Comment
Question by:tyrekicker
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 9681625
Page 62 shows you how to add a static route to the Netopia

http://www.netopia.com/equipment/pdf/manuals/4541-4542_manual.pdf
Add Static Route
Destination network = Remote LAN subnet
Mask = 255.255.255.0  <-- I'm guessing
Next Gateway = 192.168.1.3  <-- The Draytek

Done.

0
 

Author Comment

by:tyrekicker
ID: 9720887
lrmoore

Almost had to add static route to draytek's also.
Also found I had made a mistake by assigning the same ip subnet to 2 of my VPN's.


Many thanks for pointing me in the right direction.

0

Featured Post

Major Incident Management Communications

Major incidents and IT service outages cost companies millions. Often the solution to minimizing damage is automated communication. Find out more in our Major Incident Management Communications infographic.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

740 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question