slu2003
asked on
Frame Relay - v.35 port
I purchased a new Cisco 1721 router in order to replace the old NILE router for FR connection. The serial cable is CAB-V35MT, one end is V.35 and the other end is DB-60 serial.
When I tried to connect the new Cisco 1721 router, it did not get signal from ISP. Later I found the the old v.35 port and new v.35 port have different pin layout. The old v.35 has PIN on J but no on K, but the new v.35 has PIN on K but no on J. It seems that the old v.35 is not a standard port.
Did you meet the similar problem? Do you know where I can order a customized cable?
Please do NOT reply I need to call CISCO or ISP vendor because I had already done.
Thanks in advance.
When I tried to connect the new Cisco 1721 router, it did not get signal from ISP. Later I found the the old v.35 port and new v.35 port have different pin layout. The old v.35 has PIN on J but no on K, but the new v.35 has PIN on K but no on J. It seems that the old v.35 is not a standard port.
Did you meet the similar problem? Do you know where I can order a customized cable?
Please do NOT reply I need to call CISCO or ISP vendor because I had already done.
Thanks in advance.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thus I am looking for someone who had the similar experience or know which websites can make customized cable? Thanks.
ASKER