Solved

Cisco VWIC-2MFT-T1...

Posted on 2003-12-04
1
321 Views
Last Modified: 2010-04-17
We have 2 Cisco 1760 Routers with VWIC-2MFT-T1 cards in each. I want to pass a T1 from Point to Point channelized giving half the channels to a seperate device from the WAN and the remaining channels back to the WAN. Can this be done???

The project I am on is critical.
0
Comment
Question by:DarylnCA
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 9874319
Not without the "drop and insert" "DI" model of the VWIC.
It's just like I showed you in the last Q that you posted
http://www.experts-exchange.com/Hardware/Routers/Q_20815460.html#9869379

What is different now?

0

Featured Post

MIM Survival Guide for Service Desk Managers

Major incidents can send mastered service desk processes into disorder. Systems and tools produce the data needed to resolve these incidents, but your challenge is getting that information to the right people fast. Check out the Survival Guide and begin bringing order to chaos.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

730 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question