Still celebrating National IT Professionals Day with 3 months of free Premium Membership. Use Code ITDAY17

x
?
Solved

how to nat a pool of IP's on Cisco 3600

Posted on 2003-12-08
2
Medium Priority
?
439 Views
Last Modified: 2010-05-18
I have 2 networks: A - 192.168.16.0/24 & B - 192.168.12.0/24
the 2 networks are connected by Frame-Relay & but only A access B
accessing B from A require a 2nd IP on the 192.168.12.x network which is x.x.x.176/26
I can ping from 192.168.16.x to x.x.x.177 - that PC is connected to a 3rd network with VPN.
the 3rd with real IP's that can only be accessed over the VPN (C - 170.110.x.x/16 ).
I need to access network from A to C (ping is ok).
using: ip nat outside static x.x.x.176 170.110.110.10 I could ping 170.110.110.10
I need the same solution but to access all the C IP's from A
0
Comment
Question by:chuku
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 17

Author Comment

by:chuku
ID: 9900061
ok
I found a solution using ip nat outside source static for one critical IP.
0
 

Accepted Solution

by:
PashaMod earned 0 total points
ID: 9900165
Question closed and points refunded

PashaMod
Cs Moderator
0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Ready to improve network connectivity? Watch this webinar to learn how SD-WANs and a one-click instant connect tool can boost provisions, deployment, and management of your cloud connection.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

722 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question