Routing and Remote Access Server not acting as a Router. Internal Interface is non-operational.
Posted on 2004-03-24
I am using windows 2003 server standerd
I am trying to set up a VPN Server. I want it to act as a router
It doe’s not function so. I believe the problem is. I open RRAS, Under IP Routing and under General. It list 4 Interfaces
1.Internet, 2. Network, 3. Loopback, 4 Internal.
the Internal interface is non-operational and doesn't have an IP Address, the others are working
If I look under Routing Interfaces and all 4 interfaces are connected.
I have tryed to reinstall RRAS but have had no luck.The 2 NIC have differant IP Address and subnets.
I have right clicked on the server name (local) under properties and enable this computer as a Router
and selected Lan and demand-dail routing.I have gone to the Registery and have enabled. IPEnableRouter and it is still non-operational. I have no other services runing on the server,Doe's it need an other services to run properly,I don't think it is hardware everything is working fine
How can I get the internal interface operational