Xandros wired/wireless networking config

I have Xandro Linux 2.0.  As root, I can use the control panel to manually enable either my wired or wireless network connection, but it seems only one can be enabled at a time.  If I enable both eth0 (wired) and eth1(wireless), only my wired connection works.  If I disable eth0, then eth1 (wireless) works fine.

I want to be able to have both automatically.  i.e. If I unplug my cat5, I want to be able to use my wireless connection without having to do anything... is this possible?
Who is Participating?
GhostModConnect With a Mentor Commented:
PAQed, 125 points refunded.

Community Support Moderator
This is a routing problem, if you paste the output from your "route" command here i will try to help you
SciGuyAuthor Commented:
Here is the output of "route"

Destination     Gateway         Genmask         Flags Metric Ref    Use Iface     *        U     0      0        0 eth0     *        U     0      0        0 eth1
default         UG    0      0        0 eth0

SciGuyAuthor Commented:
I recently rendered by setup unusable and had to reinstall.  After stepping through the Xandros network connections wizard, things just worked the way I wanted... don't know why it didnt work the first time.
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.