Solved

Need command Reference for Cisco 2600

Posted on 2004-03-29
3
415 Views
Last Modified: 2011-08-18
Hello
I'm configuring a CISCO 2600 router, and I need a command reference.  I want a list of all the CISCO commands that I can use (via telnet).

Thanks

- Jeff
0
Comment
Question by:jeffg_91911
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 5

Expert Comment

by:visioneer
ID: 10709510
Type ? at the enable prompt.
0
 
LVL 5

Accepted Solution

by:
visioneer earned 500 total points
ID: 10709520
0
 
LVL 19

Expert Comment

by:nodisco
ID: 15658531
No comment has been added to this question in more than 21 days, so it is now classified as abandoned..
I will leave the following recommendation for this question in the Cleanup topic area:
Delete - No Refund

Any objections should be posted here in the next 4 days. After that time, the question will be closed.

nodisco
EE Cleanup Volunteer
0

Featured Post

Are You Headed to Black Hat USA 2017?

Getting ready for Black Hat next week? Kick things off with the WatchGuard Badge Challenge and test your puzzle and cipher skills. Do you have what it takes to earn our limited edition Firebox Badge? Get started today - https://crimsonthorn.net

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

To setup a SonicWALL for policy based routing to be used with the Websense Content Gateway there are several steps that need to be completed. Below is a rough guide for accomplishing this. One thing of note is this guide is intended to assist in the…
This article offers some helpful and general tips for safe browsing and online shopping. It offers simple and manageable procedures that help to ensure the safety of one's personal information and the security of any devices.
Michael from AdRem Software outlines event notifications and Automatic Corrective Actions in network monitoring. Automatic Corrective Actions are scripts, which can automatically run upon discovery of a certain undesirable condition in your network.…
Sometimes it takes a new vantage point, apart from our everyday security practices, to truly see our Active Directory (AD) vulnerabilities. We get used to implementing the same techniques and checking the same areas for a breach. This pattern can re…
Suggested Courses

636 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question