Solved

Redhat 7.3 network cannot see outside of LAN

Posted on 2004-03-29
3
235 Views
Last Modified: 2010-03-18
Just installed Redhat 7.3 and everything seemed to work ok. I noticed while I was setting it up I couldn't get to any ftp sites outside of my LAN. I setup a ftp on the LAN and the install worked. However if I try to ping the box from outside the LAN it fails. Any help is appriciated.
Thanks
0
Comment
Question by:zimmerj
  • 2
3 Comments
 

Author Comment

by:zimmerj
ID: 10710107
also I tracert to the ip and it times out a hop or 2 before the destination. I am able to runa a tracert and ping all of the other ips on the LAN
0
 
LVL 40

Accepted Solution

by:
jlevie earned 125 total points
ID: 10710301
Failing to reach an IP outside of the local LAN points to a problem with the default gateway setting on the RedHat box or a problem with the gateway router.
0
 

Author Comment

by:zimmerj
ID: 10710471
thanks, thats what it was.. had the gateway wrong
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
In this tutorial you'll learn about bandwidth monitoring with flows and packet sniffing with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're interested in additional methods for monitoring bandwidt…
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

706 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now