Solved

CONNECTING TWO ROUTERS ACROSS THE INTERNET

Posted on 2004-04-02
3
177 Views
Last Modified: 2010-04-17
I HAVE TWO 2500 CISCO ROUTER, AND I WANT TO CONNECT THEM  AT TWO DIFFERENT PLACES ACROSS THE INTERNET USING BROADBAND CABLE. HOW DO I DO THIS?
0
Comment
Question by:SUPERCOOLDUDE
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
3 Comments
 
LVL 12

Accepted Solution

by:
Scotty_cisco earned 300 total points
ID: 10742569
I would set up  a GRE tunnel like so

---------Router 1--------------

interface Tunnel1
 ip unnumbered Ethernet0
 ip nat inside
 tunnel source Ethernet0
 tunnel destination x.x.x.x (public IP address of router2)


----------Router 2------------------
interface Tunnel1
 ip unnumbered Ethernet0
 ip nat inside
 tunnel source Ethernet0
 tunnel destination y.y.y.y (public ip address of router1)

Then just make sure that you have routes accross the link using interface tunnel1

This link is very similar except you are going to use the 2500 to tunnel the data

http://www.cisco.com/en/US/tech/tk86/tk89/technologies_configuration_example09186a008011520d.shtml

This is not encrypted though and if you want to do that ... things change a bit

Thanks scott
0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

687 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question