Solved

Pcmcia Linksys WPC11 v.4 setup problem

Posted on 2004-04-11
2
386 Views
Last Modified: 2010-03-18
Hello,

The problem I am having is that when I unpack and try to install the pcmcia-cs tar, I get an error:-

Linux source tree '/usr/src/linux' is incomplete or missing!

I have the following in my src directory

[root@localhost src]# ls
debug  linux-2.4  linux-2.4.20-30.9  linux-2.4.20-6  redhat

I used the Red Hat Update service to update the kernel, and then I downloaded the source and put it in the directory

I am booting on the 30.9 , I am using the following instructions:-

http://www.linuxvoodoo.com/resources/howtos/linksysv4/

Any help with the problem would be much appreciated

Thanks
0
Comment
Question by:kama_k
2 Comments
 
LVL 5

Accepted Solution

by:
brabard earned 125 total points
ID: 10803802
Well , your makefile is trying to find kernel headers in /usr/src/linux/ instead of /usr/src/linux-2.4.20-30.9 (or whereever you have compiled kernel headers and/or sources) .
So you can :
1. Edit Makefile such as replace all dirs "linux" with "linux-2.4.20-30.9" , or
2. Just to make a symlink  "~linux" to the "linux-2.4.20-30.9"

I'd prefer the second thing , cause may be you'll try to compile other packets in future .
The command is :
[root@localhost src]#ln -s ./linux-2.4.20-30.9 ./linux
0
 

Author Comment

by:kama_k
ID: 10824177
Thanks brabard, that worked perfectly, still having problems getting the card setup, but will keep at it.

Thanks again
0

Featured Post

How your wiki can always stay up-to-date

Quip doubles as a “living” wiki and a project management tool that evolves with your organization. As you finish projects in Quip, the work remains, easily accessible to all team members, new and old.
- Increase transparency
- Onboard new hires faster
- Access from mobile/offline

Join & Write a Comment

I have seen several blogs and forum entries elsewhere state that because NTFS volumes do not support linux ownership or permissions, they cannot be used for anonymous ftp upload through the vsftpd program.   IT can be done and here's how to get i…
Note: for this to work properly you need to use a Cross-Over network cable. 1. Connect both servers S1 and S2 on the second network slots respectively. Note that you can use the 1st slots but usually these would be occupied by the Service Provide…
This video discusses moving either the default database or any database to a new volume.
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…

706 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

15 Experts available now in Live!

Get 1:1 Help Now