ellandrd
asked on
Default gateway
I have a Vigor 2600 router
A windows NT server
10 Xp xlient machines
THe router is set correctly and the internet is accesble from the server
i set the default gate on the NT server to the same ip address 192.168.0.10 as the router is on.
I get no internet coonection on the xp machines
When i go on to the XP machines and do ipconfig /all all the correct infomation is there correct DHCP server address (address of my server 192.168.0.1) correct subnet mask(255.255.255.0) but the default gate is blank.
i have rebooted the server and work stations to see if this was the problem
I have also deleted leases and renewed the leases.
Next on the Xp machines i manually put in the gateway address and did ipconfig /all and 192.168.0.10 appeared in default gate way hooraahh i hear you say
But still not net access
What my problem
Thanks in advance
Mark
A windows NT server
10 Xp xlient machines
THe router is set correctly and the internet is accesble from the server
i set the default gate on the NT server to the same ip address 192.168.0.10 as the router is on.
I get no internet coonection on the xp machines
When i go on to the XP machines and do ipconfig /all all the correct infomation is there correct DHCP server address (address of my server 192.168.0.1) correct subnet mask(255.255.255.0) but the default gate is blank.
i have rebooted the server and work stations to see if this was the problem
I have also deleted leases and renewed the leases.
Next on the Xp machines i manually put in the gateway address and did ipconfig /all and 192.168.0.10 appeared in default gate way hooraahh i hear you say
But still not net access
What my problem
Thanks in advance
Mark
ASKER
why would that stop showing the gateway????
And the server can connect to the internet???
Mark
And the server can connect to the internet???
Mark
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
H