Solved

debugging and processor load

Posted on 2004-05-01
2
191 Views
Last Modified: 2012-05-04
Hi experts

Could you tell me which would be the least router processor intensive when using a debug command:

out put to console, to vt session ?, to syslog server ?, to file server or any other ?

0
Comment
Question by:kamal73
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
2 Comments
 
LVL 50

Expert Comment

by:Don Johnston
ID: 10967186
Of the three you listed, syslog has the lowest CPU utilization.

-Don
0
 
LVL 50

Accepted Solution

by:
Don Johnston earned 500 total points
ID: 11034245
Listed from lowest (cpu load) to highest...

buffer
syslog
telnet
console

-Don
0

Featured Post

Raise the IQ of Your IT Alerts

From IT major incidents to manufacturing line slowdowns, every business process generates insights that need to reach the people required to take action. You need a platform that integrates with your business tools to create fully enabled DevOps toolchains.

You need xMatters.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

717 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question